Skip to content
Your 615 Realtor

The 615 Market Brief · Buyer Education

What is under the house: sinkholes and radon

November 16, 2026 · U.S. Geological Survey, the Metro Nashville Stormwater Management Manual, Tennessee Code Annotated sections 56-7-130 and 66-5-212, the EPA, and the TDEC Tennessee Radon Program

Buyers spend the inspection period on what they can see. In Middle Tennessee two of the more consequential questions are about what is underneath, and neither one appears in a listing.

First the ground. The Geological Survey maps Middle Tennessee as karst terrain across two regions, the Central Basin and the Highland Rim. The Central Basin sits on Ordovician limestones, with dissolution-enlarged conduits in the Carters, Ridley and Murfreesboro Limestones through the inner basin, typically concentrated within about fifty meters of the surface, and in the Bigby and Cannon Limestones through the outer basin. The Highland Rim sits on Mississippian limestones and carries sinkhole plains with high sinkhole density, most common where the purer Ste. Genevieve and St. Louis Limestones reach the surface. Soluble rock near the surface dissolves along fractures, and drainage runs internally rather than across the ground.

At a parcel level that means Metro has no map to hand you. I went through the Metro ArcGIS services: the stormwater layers publish regulation buffers for wetlands, streams, ponds and the FEMA floodway, and there is no countywide sinkhole layer. Metro pushes identification onto the individual site instead. Its Stormwater Management Manual defines a sinkhole as a depression in a karst area with no surface outflow of water, identified by the first closed contour on a two-foot contour map or as designated by the state, and it requires field-verified two-foot contours for every sinkhole, including ones offsite.

The engineering standard shows how seriously Metro treats them. A stormwater system discharging to a sinkhole has to be designed and certified by a registered engineer using the hundred-year storm and assuming plugged conditions, meaning zero outflow, and has to demonstrate that flooding will not be increased. Lost sinkhole volume from that storm has to be compensated within the development. Discharging into a sinkhole may require a state injection well permit, and the state has to approve any alteration to a sinkhole at all. So if a seller tells you the sinkhole on the lot was simply filled in, that is a question, not an answer.

On insurance, be precise, because this gets misstated constantly. Tennessee law requires insurers writing homeowner property insurance in this state to make sinkhole coverage available, and the same section says in its own text that nothing in it mandates that the coverage be included in any policy. The Department of Commerce and Insurance has confirmed the coverage has to be available on a policyholder’s request rather than only at the inception of a policy. So it exists, usually for additional premium and often after an inspection, and whether you carry it is a question for your declarations page and your endorsements rather than an assumption.

One rule does cut in a buyer’s favor. The seller must disclose a known sinkhole on the property, in writing and before the contract, and the statute defines a sinkhole as a subterranean void created by the dissolution of limestone or dolostone causing surface subsidence. That duty sits outside the ordinary disclosure form, so a completed form does not tell you the question was ever asked.

Second question, the air. Radon comes up out of that same ground. The EPA action level is four picocuries per liter, and the EPA also recommends considering a fix between two and four because there is no known safe level of exposure. For scale, the average indoor level runs about 1.3 and outdoor air about 0.4. The state program is worth using: TDEC provides free radon test kits to Tennessee residents and reports that one in four homes requesting a kit tests above four. The EPA zone maps date from 1993, and the EPA says itself that homes with elevated levels have been found in all three zones and that the map should not be used to decide whether a particular house needs testing. Test the house.

If a test comes back high, the fix is established and it is not a renovation. The usual method is active sub-slab depressurization: a pipe through the slab and a fan that draws the gas from beneath the house and vents it outside. The EPA calls it the most common and usually the most reliable method, with reductions of fifty to ninety-nine percent. Retest within thirty days of installation, and at least every two years after that. I am not going to quote you a price, because the EPA publishes no cost range at all and anyone citing a government figure for it is inventing it. Get estimates from certified mitigators.

Worth knowing what is not required. No Tennessee law requires radon testing in a sale, and radon is not one of the conditions the disclosure statute names. It reaches the paperwork only through the general duty to disclose known material defects, which means a known high result or an installed mitigation system belongs on the form, while a house nobody ever tested carries no record either way.

Both of these are answerable inside an inspection period and neither is expensive to answer. Send me the address and I will tell you which karst region the parcel sits in, what the contour map actually shows, and get a radon kit on the counter before your contingencies come off. Finding either one while we still have leverage is most of what an agent is for.